To program your DIRECTV remote, follow these steps: Power on your TV by pressing POWER on its remote or set-top box. While pressing and holding down 1, press and release any other number (2 through 16) in turn. These numbers are preset at the factory; you do not need to re-enter them. Now that all buttons are programmed, you can use your DIRECTV remote to control as many devices as there are buttons for. If you have additional devices that you want to be added, repeat Steps 1-4 above for each one. Your remote can hold up to 16 devices total—not all of which have to be set-top boxes. You can also add a new device if you’ve deleted one from your account. Just call DIRECTV customer service, give them your model number and they’ll add it back into your account.

Steps To Program Program Your Direct TV Remote RC73

Step 2: Connect the power Step 3: Connect the ground

TV input: TV port on the side of your TV Cable input: coaxial cable with one end connected to your receiver and the other end connected to an input on your TV

To power your device, you’ll need to put in batteries. ..

If you have used batteries already, it is recommended that you remove them from your remote and then insert fresh ones instead.

Step 3: Press a few buttons to start the process.

To program your remote, you’ll need two devices that use infrared signals: your DIRECTV system and a source device, such as a cable box or DVD player. To get started, turn on both devices and make sure they are within 30 feet of each other. Point your remote at one of them and press each button three times in quick succession. Wait for three seconds between clicks so that you can see whether or not each click was registered. If it wasn’t, try again. If it worked correctly, move on to Step 4.

After completing step three, you now have a remote control that can be used to change the settings on your TV. You can use this remote control to adjust the brightness, contrast, and sound of your TV.

If you’re having trouble controlling your DIRECTV remote, don’t worry - there’s a simple solution. In this tutorial, we’ll show you how to program your remote so that you can enjoy all of your favorite programming without ever having to fumble through the buttons again. If you need help with your remote or if it’s not working properly, please contact DIRECTV Customer Service at 1-800-531-5000 for assistance. Have a great day! ..

How to connect DIRECTV remote without coding?

Next, remove the battery from your remote control. Be sure to use a sharp knife to cut off the top of the battery. You will now have two pieces of battery. Now, put one piece of battery in the compartment on your remote control and put the other piece in the other compartment on your computer.

Remove the batteries from your remote control by unscrewing them one at a time until they’re all out of their compartment.

If your new batteries are also not working properly, it may be time to replace the battery pack. ..

Conclusion: 

Remember, when using your remote, that there are only 3 buttons you need to know about. Pressing and holding one of these buttons will access a different set of numbers than just tapping it once. So make sure you are pressing and holding on to each button until all four digits have been inputted. Also, always verify your work before hitting OK as there is no turning back from that point! And finally, don’t rush through everything! Yes, it may seem tedious at first but make sure you are being thorough and going through each step carefully. Now you know how to program direct tv remote rc73. Good luck with setting up your new remote control!

The DIRECTV receiver is not working properly.

If your receiver won’t turn on, the outlet may need to be reset.